DIAMOND - BB-6WS (NEW MODEL) - SINGLE WIRE WIDE BAND ANTENNA operating from 3 to 30 MHz - 250W p.e.p. SSB max. power

The Diamond BB6WS HF Wideband Antenna is perfect for smaller gardens that have limited space to place antennas in.

It is very similar to the BB7V, however the BB6W has a horizontal wire section after the loading coil / balun instead of a vertical section. 

The BB6WS is non adjustable and will need an ATU to get the SWR to less than 1.5:1.

Specifications:

Frequency: 3-30MHz (with antenna tuner)
Impedance: 50 Ohm 
VSWR < 2:1 (3-30MHz)
Connector Type: SO-239
Nylon braided cord (5m) 
Length: 6.4m (21ft) 

DIAMOND - W-735 - 40 & 80 METERS DIPOLE

This is a dual band antenna that covers 80m and 40m (3,5 & 7 MHz).
It does this by virtue of chocke traps.

These trap the centre of the antenna off allowing it to operate as a full size 40 m. dipole.

On 80m they operate as loading colils and thus considerably shorten the antenna on this band.

The antenna also features Diamond's 1:1 balun.

The whole anenna is rated up tp 1.2kW p.e.p. SSB and the balun feedpoint is an SO-239 socket. 

The overall length of the antenna is approximately 21 m. depending on the fine tuning of the end 80 m. sections.

The overall length of the antenna can be reduced if it is erected as an inverted V.

With an overalllength of 70 ft., if installed as an inverted V it can be fitted into a garden length of around 50 ft. or so.

This makes it one of our most popular LF antennas for small gardens. 
Weight: 1,85 kg.

DIAMOND - WD-330 - WIDE BAND CONTINUOUS COVERAGE 2-30 MHz WIRE ANTENNA, T2FD FOLDED DIPOLE TYPE - 150W p.e.p. SSB

The WD330 was born from a project for severe commercial broadcast applications from 2 to 30 Mhz,
adapted to the space requirements typical of European radio amateurs: a very valid choice from a qualitative point of view.
This type of antenna is also known as T2FD (Terminated Folded Dipole).

It is made of specific copper braid for use, covered with high quality protective PVC.
Supplied complete with exceptionally robust fiberglass spacers, broadband device and balun, which allow adaptation to the 50 ohm power supply line.

It comes already pre-calibrated and assembled. You will therefore not have to measure, cut, stretch or calibrate anything.

The WD330 can be installed horizontally for maximum efficiency, but it can be perfectly installed as an inverted "V" and as a sloper. Some seem to have already installed them in "sloper" systems composed of multiple, single or coupled WD330 antennas to obtain greater gain, directivity and signal discrimination.

If mounted sufficiently far from obstacles and metal structures, the performance is very good and the SWR within the specifications.

Length: 25 m

Weight: 3.1 kg 

Max.power rating: 150W(PEP)

Impedance: 50 ohm

Connector: MJ (SO-239)

Coaxial cable: 30 m 5D-2V low-loss 50 ohm coax cable INCLUDED

DIAMOND - WD-330 - WIDE BAND CONTINUOUS COVERAGE 2-30 MHz WIRE ANTENNA, T2FD FOLDED DIPOLE TYPE - 150W p.e.p. SSB

Length: 25 m

Weight: 1,7 kg

Max.power rating: 150W(PEP)

Impedance: 50 ohm

Connector: MJ (SO-239)

G5RV FULL SIZE - ANTENNA 10-80 METERS (3,5 - 30 MHz) , no traps - L=31 m. - Max. input power = 1 kW p.e.p. SSB

The G5RV Full Size HF Wire Antenna is an HF Amateur Band, Receive and Transmit Antenna, covering 80m to 10m
bands.

Its overall length is 102 feet , and should be fed with good quality 50 Ohms coaxial cable (recommended feed length of 45 or 90 ft).
The ribbon cable, about 10 meters long,  should hang downwards and forms part of the radiating antenna.

To achieve optimum results, this antenna should be mounted as high as possible, either horizontally or in an inverted “V” formation, with the centre mounted at least 36 ft from the ground.

The superior Full Size G5RV comes fully assembled & ready to go.

Also, the Poly Weave wire will not  kink and is extremely strong.

Excellent for use where space is limited, good for unobtrusive garden or attic
installation and also highly recommended for Short  Wave listening.

UK manufactured and supplied complete with ladder feed and Dog Bone
fittings.

Frequency 3.5-30 MHz
Bands 80-10 metres
Full length 102 feet
2 x 51 feet poly weave no kink wire elements
Ladder ribbon cable
Feeder terminated in SO-239 Socket
2 x dog bone insulators

Complete with instruction sheet
Made In Great Britain

The superior full size G5RV comes fully assembled and ready to go.

LW-20 - END-FED LONG WIRE MULTI-BAND ANTENNA 80 - 6 m. ,(3,5 - 52 MHz), max. input power 400W p.e.p. SSB

The LW-20 is an end fed long wire aerial.

It incorporates a 9:1 UNUN at the feedpoint enabling it to be fed directly with 50 Ohm coaxial cable.

The 9:1 UNUN also removes static noise and provides a DC path to earth.
 

LW-20 can handle up to 400W RF p.e.p. SSB

LW-20: 20m in length, this will work on all bands from 80m – 6m via an ATU. Big performance from a small foot print.

These antennas give excellent results where space is at a premium.
However, please note that due to the varying impedance found on any long wire antenna, the built in ATU in your average transceiver will not be able to cope with all bands.

For full band coverage you will need an external ATU or possible some form of capacitive loading system.

This can be a simple L or T match.

The LW-20 comes fully assembled and ready to go.
Also the poly weave wire will not kink and is extremely strong.

Specifications:

Type: End Fed Wire Antenna

Frequency: 3.5 – 52 MHz
Band: 80-6m
Power: handling 400W, RF p.e.p. SSB
Impedance: 50 Ohms
Connector: SO-239
Length: 20.28 Meters
Non-Kink Poly Weave Wire

Made in Great Britain

DIAMOND - W-8010 - WIRE DIPOLE for 10 - 15 - 20 - 40 - 80 METERS (28 - 21 - 14 - 7 - 3.5 MHz) - 1200W p.e.p. SSB

ECO - 6.6 MHz WIRE DIPOLE 45 METERS BAND - ASSEMBLED - COMPLETE WITH CENTRAL AND END INSULATORS - MAST BRACKET INCLUDED

The dipole antenna has always provided excellent performance at an affordable price.
It can be installed between two support points, as an inverted "V".
In the first case the radiation pattern will be perpendicular to the conductor, with a typical "8" figure that exhibits gain in those directions.
In the second case, it will be advantageous to use only one support, for which a special galvanized bracket is supplied, making a radiation diagram a little more uniform in the various directions.
The greater the height from the ground, the lower the angle of radiation, suitable for DX contacts.

Antenna Lenght = about m. 22 

The antenna is factory pre-tuned. It can be optimized by slightly lenghtening or shortening the ends.
By shortening the antenna to about 20.10 meters it can become an excellent monoband 40 meters dipole.
As an option to further improve radiation you can substitute the central isolator with a voltage or current balun.

Max. input power: 2000 Watt P.e.P. SSB 
Lenght: 22 meters (11 mt./arm)
V.S.W.R.: 1:1.2
Impedance: 50 Ohm
Connector: SO 239

ECO - 85 - WIRE DIPOLE FOR 10-15-20-40-80 METERS (28-21-14-7-3.5 MHz) - 4 LEGS - Maximum lenght = 22 m

Wire dipole antenna with 4 arms, 2 for 10-15-20 meters and 2 for 40-80 meters.

It can be mounted in various ways: as an inverted "V" with orthogonal arms, to also act as guy wires to the support pole, or by spreading the longer part horizontally and the shorter one as an inverted "V", as shown in the drawings.

Pre-tuned at the factory it rarely needs to be adjusted if mounted sufficiently high to not be influenced by adjacent structures.

Given its length, it is able to offer excellent performance on the lower bands.

Max. input power: 1000 Watt P.e.P. SSB 
Lenght: about 22 meters (11 m / arm) for the longest dipole covering 40/80 meters band and about 7 meters (3.5 m / arm) for the shortest dipole covering 10-15-20 meters band
V.S.W.R.: 1:1.2
Impedance: 50 Ohm
Connector: SO 239

NOTE: THE PACKAGE IN THE PICTURE MAY VARY DEPENDING ON THE PRODUCTION LOTS

ECO - WIRE DIPOLE FOR 45 & 88 METERS (6.6 & 3.4 MHz) - Maximum lenght = 22 m. - Mounting bracket included 

Wire dipole antenna for 45 and 88 meters.

It can be mounted as an inverted "V" or by spreading it all horizontally.

Pre-tuned at the factory it rarely needs to be adjusted differently if mounted sufficiently high to not be influenced by adjacent structures.

Given its length, it is able to offer excellent performance on the lower bands.

Max. input power: 1000 Watt P.e.P. SSB 
Lenght: 22 metri (11 mt./arm)
V.S.W.R.: 1:1.2
Impedance: 50 Ohm
Connector: SO 239