MUSIC AUDIO RADIO-ELECTRONICS COMPUTER
In stock
RF CONCEPTS - 2/70G - VHF/UHF AMPLIFIER with GaAsFet receive preamplifiers - 143-149 30W max. out / 430-450 MHz - 20W max. out
The RFC 2/70G is a dual-band power amplifier and dual-band receiver pre-amplifier combined as one.
The main features are automatic keying and amplification of RF energy from your dual-band hand-held (HT).
When the HT power output is sensed by either the 2-meter or 70-cm narrow band peak detector, the preamp is switched out and the power amplifier is switched on.
The two front panel switches allow for independent selection of the power amp, pre-amp or both.
The RFC 2/70G features two GaAsFets as the pre-amplifiers, one for each band.
FETs provide good gain and noise figure.
An added feature is the addition of PIN diodes as protection circuitry at the front-end and output of the FETs.
In addition, the RFC 2/70G features fast coaxial relay switching, generally less than 20 ms.
The relays are 50-ohm compatible, sealed and require low power to latch and control, making the RFC 2/70G ideal also for high-speed packet applications.
SPECIFICATIONS
Frequency range | 143-149 MHz |
430-450 MHz | |
Power | 143-149 5w in= 30w out* |
430-450 5w in = 20w out* | |
Minimum input | 500mw |
Maximum input | 7 watts |
Duty cycle | lntermittent (not for repeater service) |
Modes | FM, CW, PACKET |
GaAsFet Preamp | 143-149 - Noise Figure - 1 to 3 dB - Gain -15 dB nominal |
430-450 - Noise Figure - 2 to 4 dB - Gain -10 dB nominal | |
Keying | Automatic - RF sensing, band selectable |
TR switching | < 20ms |
Input-output impedance | 50 ohm nominal |
Voltage requirements | 13.5 V DC |
Current requirements | < 6 amps |
Size | 3.5" x 2.0" x 8.0" ( cm. 8,9 x 5,1 x 20,38 ) |
*output may vary by a dB |
English Manual and circuit diagram included.
Mon |
10:00 16:30 |
- |
12:30 19:30 |
Tue |
10:00 16:30 |
- |
12:30 19:30 |
Wed |
10:00 16:30 |
- |
12:30 19:30 |
Thu |
10:00 16:30 |
- |
12:30 19:30 |
Fri |
10:00 16:30 |
- |
12:30 19:30 |
Sat | 16:30 | - | 19:30 |
Sun | Closed |